I have configured VMware SRM 6.1.1.2 with RecoverPoint SRA 2.2.0.3. All tests include the following steps have done successfully.
Test recovery mode was donec correctly and I am capability of return to main site by Cleanup button.
Meanwhile, Fail over recovery in Planned migration is done and after that I could be able to Reprotect and fail back in Planned migration to the production site.
My only problem is when I'm going to do fail over and fail back in Disaster recovery mode! first, I shutdown all the hosts suddenly and then run the recovery plan in Disaster recovery mode. It will be done successfully and therefore, all VMs will be power on in the disaster site. On the contrary, Reprotect button is not able and it would be grayed If I wanna to fail back to production site.
Should it be reversed and returned to main sites from EMC RecoverPoint?
what are your opinions about this circumstance?