I am using SRM 5.1 with vSphere 5.1. I have 20 vms being protected by SRM. We have one virtual replication appliance at each site. The total disk space for these 20 vms is roughly 6 TB. We have a 200 MB MPLS between the primary and recovery site. The only traffic going over this link is SRM replication.
All of my protected vms show success for state and no errors are present under the SRM plugin inside of vCenter. When I run the cli command to get the replication status for my vms, they are all showing 3% or less. This process has been running for 2 full days. When I look at the last sync time its blank. When I look at the recovery site I see the shadow vms, but the amount of disk usage is very small. I selected thick provision when I enabled replication on the vms. What am I missing? Is there a good way to tell for sure if these vms are fully synced? We currently have the RPO set to 24 hours. The goal is to get the down to 30 minutes.
Thanks,
Ed