I am going through the intial config of setting up SRM. I have two vcenter servers and sites setup, and was able to deploy the VRMS server for the recovery site. However, on the source/protected site, the VRMS server I setup is having an issue. I use the "configure from existing VRM database" and use the same DB for VRMS that the recovery site uses (i assume you don't need a separate database for each VRMS site server?). And it saves the config without issue and starts the VRM service. But after about 3-4 minutes, the VRM service stops. If I restart it, it runs for a couple minutes but stops. Any idea why? 
↧
VRM service keeps stopping
↧